DOUBLE HUMP FIBERGLASS REAR FENDERS

The WTI Double Hump Fenders have the same styling as our single fenders with a few added features.

This fender is molded together in the middle. It gives you the look of two fenders, but it is actually one fender. The fender was lengthened on both ends and the middle, which allows easier access to the brackets on a truck with 24.5 tall tires. Also, on the lower outside center we have molded a place to add a side marker light.

There are three brackets used on each side of the truck to give proper support to the fender.  The same "hidden" bracket design is used on the "double humps" that is used on the regular full fenders with an added supporting bracket in the middle.   

Gel Coat Colors

	Gray Primer
	Black
	White

Painting

The black and white gloss gel coat can be waxed and installed without painting.  

Mounting Brackets

	Tubular steel with 1/4" wall
	Flat plates 3/8" thick
	Gusseted corners
	Mitered cuts
	Capped ends
	Grade 8 & stainless bolts included
	Built Tuff - Built to Last
	Available with Standard (52") spacing
	Weight: 275 pounds per set (including brackets) (Approximate)

We offer technical support by phone at 920-822-2471 during regular business hours. 

Prices are subject to change.
US Dollars

Recommended 5th Wheel Height for all W.T.I. Fenders
(measure from ground to top of fifth wheel)

If you have:
22.5 low pro tires	48"
22.5 standard tires	49"
24.5 low pro tires	49"
24.5 tall rubber	51"

This is the minimum height we recommend. This does not guarantee you will not hit the fenders with the trailer, but in our experience it has been sufficient. The higher the 5th wheel the better!

DOUBLE HUMP FENDERS WITH ALL BRACKETS 

$ 1,999.95  PAIR